Features:
1. Stable performance with advanced PLC.
2. Conveying preforms automatically with conveyor.
3. Strong penetrability and good and swift distribution of the heat by letting the bottles rotate by itself and revolute in the rails simultaneously in the infrared preheater.
4. High adjustability to enable the preheater to preheat preforms in shapes by adjusting the light tube and the length of the reflecting board in the preheating area, and eternal temperature in the preheater with an automatic thermostatic apparatus.
5. High safeties with security automatic-locking apparatus in each mechanical action, which will make the procedures turn into a state of safety in case of a breakdown in certain procedure.
6. No contamination and low noise with the air cylinder to drive the action instead of the oil pump.
7. Satisfaction with different atmospheric pressure for blowing and mechanical action by dividing the blowing and action into three parts in the air pressure diagram of the machine.
8. Strong clamping force with high pressure and double crank links to lock the mold.
9. Two ways of operating: Automatic and manual.
10. Safe, reliable, and unique design of the position of valve to make the air pressure diagram of the machine easier to understand.
11. Low cost, high efficiency, easy operation, easy maintenance, etc, with automatic technological process.
1. Stable performance with advanced PLC.
2. Conveying preforms automatically with conveyor.
3. Strong penetrability and good and swift distribution of the heat by letting the bottles rotate by itself and revolute in the rails simultaneously in the infrared preheater.
4. High adjustability to enable the preheater to preheat preforms in shapes by adjusting the light tube and the length of the reflecting board in the preheating area, and eternal temperature in the preheater with an automatic thermostatic apparatus.
5. High safeties with security automatic-locking apparatus in each mechanical action, which will make the procedures turn into a state of safety in case of a breakdown in certain procedure.
6. No contamination and low noise with the air cylinder to drive the action instead of the oil pump.
7. Satisfaction with different atmospheric pressure for blowing and mechanical action by dividing the blowing and action into three parts in the air pressure diagram of the machine.
8. Strong clamping force with high pressure and double crank links to lock the mold.
9. Two ways of operating: Automatic and manual.
10. Safe, reliable, and unique design of the position of valve to make the air pressure diagram of the machine easier to understand.
11. Low cost, high efficiency, easy operation, easy maintenance, etc, with automatic technological process.
| General Information | MG-120 |
| Clamping Force | 34T |
| Clamping Stroke | 330mm |
| Max.Stretching Stroke | 550mm |
| Bottom Moving Stroke | 70mm |
| Number of Cavities | 1Cavity |
| Theoretical Output | 120BPH |
| Max.Mould Thickness | 400mm |
| Space Between Tie Bars | 52 0 × 600mm |
| Electrical System | |
| Voltage Standard | 380v/3PH/50Hz or special order |
| Number of Heating Zone | 2Sections |
| Total Power(Full Loaded) | 15KW |
Container | |
| Max.Container Volume | 25L |
| Neck Diameter Range | 65mm |
| Max.Container Diameter | 400mm |
| max.container Height | 550mm |
Auxiliary System | |
| Low Air compressor | 8-10Bar |
| High Air compressor | 30Bar |
| Air Dryer | 2.0/30 |
Dimension & Weight(L × W × H) | |
| Blow molding machine | 260 × 190 × 195cm |
| Preform Oven | -- |
| Net Weight | 5.2T |