Perkins Engine:
Perkins® 403D-11G 4 Cycle, water-Cooled, Vertical Inline Diesel Engine
Standby-15.3hp @ 1800rpm
Prime -13.9hp @ 1800rpm
3 cylinders:
1.1 L displacement
Fuel consumption(prime)-0.60 gph (2.0Lph)
Industrial engine exhaust system
Rubber vibration dampers isolate engine/generator from frame
Full flow oil filter, spin on type
Fuel filter with replaceable element
Dry type cartridge air filter
Q235A steel fuel tank with large diameter opening
36 gal. Capacity
2" fill port
Compression ratio: 23:1
Dimensions : 946*840*497mm
Starting System: Electric starting
Low cost, high efficiency, compact structure, environment friendly.
Direction of rotation : Counterclockwise(viewed from flywheel)
Stamford® alternator:PI044E
Brushless ,single phase
Standby power: 6.7KW
CONTROL SYSTEM: STANDARD AS480 AVR (SELF EXCITED)
VOLTAGE REGULATION: ± 1.0 %
CONTROL SYSTEM: AS480 AVR WITH OPTIONAL EXCITATION BOOST SYSTEM (EBS)
INSULATION SYSTEM: CLASS H
PROTECTION: IP23
RATED POWER FACTOR: 0.8
STATOR WINDING: SINGLE LAYER CONCENTRIC
WINDING PITCH: TWO THIRDS
WINDING LEAD: 4
WAVEFORM DISTORTION: NO LOAD < 1.5% NON-DISTORTING LINEAR LOAD < 5.0%
MAXIMUM OVERSPEED: 2250 Rev/Min
SHIPPING WEIGHTS: 100 kg
Control system: GU641CC
Brand :Harsen
Completed gen-set parameter display, perfect protection and control function
All English display, friendly operation interface
Excellent anti-jamming function, adapt to extreme condition.
Independent over-load protection
Special on-off pre-warning system
Unique sensors protection, adapt to all sensors
Emergency stop button and with auto starting system
Four light fixtures 1000 watts each - Metal Halide
Round aluminum reflector
Tempered glass lens
Silicone gaskets for moisture and dust protection
Individual floodlight On/Off switches
Wirings
All wiring is sized to the amperage draw require
AC & DC wiring diagrams are provided in service manual
Mask
30' maximum extension, 3-section, tubular steel
UHMW glide pads on all sides of mast tubes
Standard fully galvanized mast sections
Automatic locking system in horizontal position for travel
1500 lb. automatic self-braking winch
359° rotation with locking system
Retractable coiled mast cord
Galvanized mast cord protection
Single winch system located inside the cabinet for protection from the elements.
Equipped with single lifting eye and fork pockets
UV& fade resistant, high temperature cured, white polyester powder paint
Internal light storage system
Removable tongue - 47" long
Tubular steel chassis 2.5" x 3/16"
Three, 3000 lb. adjustable leveling jacks 3 point stance
All jacks transport and lock in horizontal position for storage
Side outriggers - 9' 10" span
Safety chains with s-hooks
2" ball hitch
Steel fenders 14 gauge
DOT approved tail, side, brake, and directional lights
Recessed rear and side lights
3500 lb. leaf spring axle
P205/75L15 tires
72" axle span
Cold weather package:
Battery heater blanket
Engine block heater
Fuel/Water Separator Filter System and Assembly
Fuel Line Heater with Automatic Thermostat
Low temperature coolant mixture (-40° F)
Documents: installation and maintenance manual, operation manual,gensets ex-factory test report, quality certificate, parts catalog, instruction of electric fuel control governor
Base feul tank,muffler and flexible pipe
Engine for EPA Interim TIER 4
Perkins® 403D-11G 4 Cycle, water-Cooled, Vertical Inline Diesel Engine
Standby-15.3hp @ 1800rpm
Prime -13.9hp @ 1800rpm
3 cylinders:
1.1 L displacement
Fuel consumption(prime)-0.60 gph (2.0Lph)
Industrial engine exhaust system
Rubber vibration dampers isolate engine/generator from frame
Full flow oil filter, spin on type
Fuel filter with replaceable element
Dry type cartridge air filter
Q235A steel fuel tank with large diameter opening
36 gal. Capacity
2" fill port
Compression ratio: 23:1
Dimensions : 946*840*497mm
Starting System: Electric starting
Low cost, high efficiency, compact structure, environment friendly.
Direction of rotation : Counterclockwise(viewed from flywheel)
Stamford® alternator:PI044E
Brushless ,single phase
Standby power: 6.7KW
CONTROL SYSTEM: STANDARD AS480 AVR (SELF EXCITED)
VOLTAGE REGULATION: ± 1.0 %
CONTROL SYSTEM: AS480 AVR WITH OPTIONAL EXCITATION BOOST SYSTEM (EBS)
INSULATION SYSTEM: CLASS H
PROTECTION: IP23
RATED POWER FACTOR: 0.8
STATOR WINDING: SINGLE LAYER CONCENTRIC
WINDING PITCH: TWO THIRDS
WINDING LEAD: 4
WAVEFORM DISTORTION: NO LOAD < 1.5% NON-DISTORTING LINEAR LOAD < 5.0%
MAXIMUM OVERSPEED: 2250 Rev/Min
SHIPPING WEIGHTS: 100 kg
Control system: GU641CC
Brand :Harsen
Completed gen-set parameter display, perfect protection and control function
All English display, friendly operation interface
Excellent anti-jamming function, adapt to extreme condition.
Independent over-load protection
Special on-off pre-warning system
Unique sensors protection, adapt to all sensors
Emergency stop button and with auto starting system
Floodlights
Four light fixtures 1000 watts each - Metal Halide
Round aluminum reflector
Tempered glass lens
Silicone gaskets for moisture and dust protection
Individual floodlight On/Off switches
Wirings
All wiring is sized to the amperage draw require
AC & DC wiring diagrams are provided in service manual
Mask
30' maximum extension, 3-section, tubular steel
UHMW glide pads on all sides of mast tubes
Standard fully galvanized mast sections
Automatic locking system in horizontal position for travel
1500 lb. automatic self-braking winch
359° rotation with locking system
Retractable coiled mast cord
Galvanized mast cord protection
Single winch system located inside the cabinet for protection from the elements.
Equipped with single lifting eye and fork pockets
Enclosure
Steel enclosure 14-gaugeUV& fade resistant, high temperature cured, white polyester powder paint
Internal light storage system
Trailer
Mast support 5" x 3/16" square tubeRemovable tongue - 47" long
Tubular steel chassis 2.5" x 3/16"
Three, 3000 lb. adjustable leveling jacks 3 point stance
All jacks transport and lock in horizontal position for storage
Side outriggers - 9' 10" span
Safety chains with s-hooks
2" ball hitch
Steel fenders 14 gauge
DOT approved tail, side, brake, and directional lights
Recessed rear and side lights
3500 lb. leaf spring axle
P205/75L15 tires
72" axle span
Cold weather package:
Battery heater blanket
Engine block heater
Fuel/Water Separator Filter System and Assembly
Fuel Line Heater with Automatic Thermostat
Low temperature coolant mixture (-40° F)
Attachment list:
.Installation: all kinds of filters, radiator, MCCB breaker, battery, battery cable, anti-vibration matsDocuments: installation and maintenance manual, operation manual,gensets ex-factory test report, quality certificate, parts catalog, instruction of electric fuel control governor
Base feul tank,muffler and flexible pipe
Certification:
SGS certified test reportEngine for EPA Interim TIER 4
Standard Equipment | NPLT 7-P |
Long(mm) | 4200 |
Wide(mm) | 1250 |
Height(mm) | 1730 |
Mast Height(m,Fully Extended) | 9.1 |
Weight(kg) | 900 |
Engine Model | 403D-11 |
Frequency(Hz) | 60 |
Speed(rpm) | 1800 |
Continuing power(kw) | 7.7 |
Number of cylinders | 3 |
Diesel Engine Characters | 4 cycle, In line, water cooled Diesel |
Combustion Type | Indirect Injection |
Engine Aspiration | Naturally aspirated |
Emission levels | EPA Interim TIER 4 |
Alternator | Brushless & Single phase |
Rating Voltage (V) | 240 |
Alternator Insulation | H |
Fuel Tank Type | Bunded Tank |
Fuel tank capacity | 120L |
Fuel Tank Operating Hours | 60 |
Type of Lights | |
Number & Power of Lights | 41000W |
Mast Lifting & Extension | Hydraulic operation |
Poles stretch the time required |
Less than 30Second |
Mast Rotation | 359° Hydraulic operation |
Irradiation angle adjustment | 90°DC electric operation. |
Mast Lifting & Extension | Hydraulic operation |
Trailer suspension system | Hexagon rubber axis |
Braking system | Inertia drum braking with adjustable hitch in height |
Hitch | Ball or O ring |
Tire Rim Size | 14 inches |
Output sockets | 1piece(240V,70A) |
Acoustic Pressure | 75dB(A) at 7 meters away |
Max.load quantity in a 40' container (sets) | 9 |